This tab is welded to the fuselage structure and is used to mount the floorboards in the front and rear cockpits.

This tab is welded to the fuselage structure and is used to mount the rudder pedals in the front cockpit.

This tab is welded to the fuselage structure and is used to mount the rudder pedals in the rear cockpit.

This step is made from the 81903 drawing and has welded end to keep out moisture and the correct 81911-2 mounting tab.

This Pulley is 1" in diameter and has a .375" wide x .188" ID oilite bushing installed and can be used with 1/32 - 1/8 cables. Made from 6061-T6 and anodized for corrosion protection.

This Pulley is 1 3/4" in diameter and has a .375" wide x .188" ID oilite bushing installed and can be used with 1/32 - 1/8 cables. Made from 6061-T6 and anodized for corrosion protection.

This Pulley is 2 3/4" in diameter and has a 5/16" ID double sealed ball bearing and can be used with 1/16 - 1/8 cables. Made from 6061-T6 and anodized for corrosion protection. With a AN960-516 washer on each side of the bearing, the mount width is .400".

This bracket welds to the fuselage in front of the torque tube to mount the front elevator cable pulley.

The J-Hook Aviation Headset Hanger is designed to be installed on one of the tube cross members in the cockpit of aircraft with exposed tubing upon which to hang your headsets when not in flight. These types of aircraft include Huskies, Cubs, Citabrias, etc. This makes entering or exiting the aircraft much easier and eliminates the chance of damaging your headset or the interior of the aircraft. This product has been machined from 6061-T6 aluminum with stainless steel hardware for a lifetime of service. Mounts to a 3/4" tube.